Debug Ipv6 Pim - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

debug ipv6 pim

Syntax
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
debug ipv6 pim
{ pimLog [ severity { severityValue | severityNumber } ] [ verbosity verbosityLevel ] |
switchState groupAddress sourceAddress |
dense-mode { on | off } |
sparse-mode { on | off | sg-state [ group groupAddress
[ source sourceAddress ] | rp rpAddress ] [ count ] } }
no debug ipv6 pim pimLog
Command introduced before JunosE Release 7.1.0.
Shows information about the selected variable. The no version disables the display.
pimLog—PIM log of interest; one of the following options:
autoRp-rcvd—Auto-RP packets received
autoRP-sent—Auto-RP packets sent
engineering—PIM engineering
hellos-rcvd—PIM hello messages received
hellos-sent—PIM hello messages sent
packets—PIM packets received and sent
packets-rcvd—PIM packets received
packets-sent—PIM packets sent
severity—Specifies the minimum severity of the log messages displayed for the selected
category; described either by a descriptive term—severityValue—or by a corresponding
number—severityNumber—in the range 0–7; the lower the number, the higher the
priority:
emergency or 0—System unusable
alert or 1—Immediate action needed
critical or 2—Critical condition exists
error or 3—Error condition
warning or 4—Warning condition
notice or 5—Normal but significant condition
info or 6—Informational message
debug or 7—Debug message
Chapter 5: D Commands
489