Debug Ip Rip - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

debug ip rip

Syntax
Release Information
Description
Options
Mode
486
debug ip rip ripLog [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ]
no debug ip rip ripLog
Command introduced before JunosE Release 7.1.0.
Shows information about the selected variable. The no version disables the display.
ripLog—RIP log of interest; one of the following options:
events—General RIP events, such as removing RIP from an interface or creating the
RIP process
route—Events associated with two RIP routers exchanging routes
severity—Specifies the minimum severity of the log messages displayed for the selected
category; described either by a descriptive term—severityValue—or by a corresponding
number—severityNumber—in the range 0–7; the lower the number, the higher the
priority:
emergency or 0—System unusable
alert or 1—Immediate action needed
critical or 2—Critical condition exists
error or 3—Error condition
warning or 4—Warning condition
notice or 5—Normal but significant condition
info or 6—Informational message
debug or 7—Debug message
verbosityLevel—Verbosity of the log category's messages; can be any of the following:
low—Terse
medium—Moderate detail
high—Verbose
Privileged Exec
Copyright © 2010, Juniper Networks, Inc.