Debug Ip Ospf - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

debug ip ospf

Syntax
Release Information
Description
Options
482
debug ip ospf ospfLog [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ]
no debug ip ospf ospfLog
Command introduced before JunosE Release 7.1.0.
Shows information about the selected variable. The no version disables the display.
ospfLog—OSPF log of interest; one of the following options:
adj—OSPF adjacency events
elect-dr—OSPF designated router election
events—OSPF general events
lsa—OSPF link-state advertisements events
neighbor—OSPF neighbor state machine
packets-rcvd—OSPF packets received
packets-sent—OSPF packets sent
route—OSPF route events
spf—All OSPF shortest path first calculation events
spf-ext—OSPF shortest path first external route calculation events
spf-inter—OSPF shortest path first interarea route calculation events
spf-intra—OSPF shortest path first intra-area route calculation events
severity—Specifies the minimum severity of the log messages displayed for the selected
category; described either by a descriptive term—severityValue—or by a corresponding
number—severityNumber—in the range 0–7; the lower the number, the higher the
priority:
emergency or 0—System unusable
alert or 1—Immediate action needed
critical or 2—Critical condition exists
error or 3—Error condition
warning or 4—Warning condition
notice or 5—Normal but significant condition
Copyright © 2010, Juniper Networks, Inc.