Section 19 Multimedia Card Interface (MCIF)
sequence is detected by poling the BUSY flag in CSTR, the data transfer end interrupt (DTI),
or the data response end interrupt (DPRI).
• The end of the data busy state is detected by poling the DTBUSY flag in CSTR or by the data
busy end interrupt (DBSYI).
Single-block data write (Block size ≤ Transmit data FIFO size)
MCCLK
CMD24 (WRITE_SINGLE_BLOCK)
MCCMD
Command
MCDAT
Command
(CMDSTRT)
transmission
started
START
(OPCR)
DATAEN
CMDOFF
(INTSTR0)
CMDI
CRPI
DTI
DRPI
DBSYI
FEI
(CSTR)
CWRE
BUSY
FIFO_EMPTY
DTBUSY
DTBUSY_TU
REQ
Figure 19.12 Example of Command Sequence for Commands with Write Data (1)
Rev. 3.00 Jan 25, 2006 page 670 of 872
REJ09B0286-0300
Command response
Single-block write command execution sequence
Status
Write data
Busy