Renesas H8S/2158 User Manual page 705

Bit Bit Name
1 DBSYI
0 BTI
Note: * Only 0 can be written to clear the flag.
Initial Value R/W
R/(W) *
0
R/(W) *
0
Section 19 Multimedia Card Interface (MCIF)
Description
Data Busy End Interrupt Flag
0: No interrupts
1: MCIFI1 interrupt requested.
[Setting condition]
•
When data busy state ends while DBSYIE =
1 in INTCR0. (When the DTBUSY bit in
CSTR is cleared.)
[Clearing condition]
•
Write 0 after reading DBSYI = 1.
Multiblock Transfer End Interrupt Flag
0: No interrupts
1: MCIFI1 interrupt requested.
[Setting condition]
•
When the number of bytes of data transfer
specified in TBCR ends after TBNCR has
been decremented to 0 by the extension
command (multiblock transfer) in SPI mode
while BTIE = 1 in INTCR0.
[Clearing condition]
•
Write 0 after reading BTI = 1.
Rev. 3.00 Jan 25, 2006 page 651 of 872
REJ09B0286-0300