Usb Port Control Register (Uprtcr), And Usb Test Registers 0 And 1 (Utestr0 And Utestr1) - Renesas H8S/2158 User Manual

18.3.22 USB Port Control Register (UPRTCR), and USB Test Registers 0 and 1 (UTESTR0
and UTESTR1)
UPRTCR, UTESTR0, and UTESTR1 are used for testing. Note that values other than initial
values must not be set to UPRTCR, UTESTR0, and UTESTR1.
UPRTCR, UTESTR0, and UTESTR1 are initialized to H'00 by a system reset. UPRTCR,
UTESTR0, and UTESTR1 are not initialized in software standby mode.
UPRTCR
Bit Bit Name Initial Value R/W
7 to 3 — All 0
2 PCNMD2 0
1 PCNMD1 0
0 PCNMD0 0
UTESTR0
Bit Bit Name Initial Value R/W
15 to TEST15 to All 0
8 TEST8
UTESTR1
Bit Bit Name Initial Value R/W
7 to TEST7 to All 0
0 TEST0
Section 18 Universal Serial Bus Interface (USB)
Description
R Reserved
These bits are always read as 0 and cannot be
modified.
R/(W) Test Mode Setting
Initial values must not be modified.
R/(W)
R/(W)
Description
R/(W) Test Mode Setting
Initial values must not be modified.
Description
R/(W) Test Mode Setting
Initial values must not be modified.
Rev. 3.00 Jan 25, 2006 page 601 of 872
REJ09B0286-0300