Hwtacacs Nas; Hwtacacs Scheme - H3C s3600 series Command Manual

Examples
# Display stop-accounting requests buffered for HWTACACS scheme hwt1.
<Sysname> display stop-accounting-buffer hwtacacs-scheme hwt1
hwtacacs nas-ip
Syntax
hwtacacs nas-ip ip-address
undo hwtacacs nas-ip
View
System view
Parameters
ip-address: Source IP address to be set, an IP address of this device. This address can neither be the
all 0's address nor be a Class D address.
Description
Use the hwtacacs nas-ip command to set the source address of outgoing HWTACACS messages.
Use the undo hwtacacs nas-ip command to restore the default setting.
By default, no source address is specified, and the IP address of corresponding outbound interface is
used as the source address.
Note that:
You can specify the source address of outgoing HWTACACS messages to avoid messages
returned from server from being unable to reach their destination due to physical interface trouble.
It is recommended to use a Loopback interface address as the source IP address.
You can specify only one source IP address by using this command. When you re-execute this
command again, the newly set source IP address will overwrite the old one.
Related commands: nas-ip.
Examples
# Configure the switch to use source address 129.10.10.1 for outgoing HWTACACS messages.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs nas-ip 129.10.10.1

hwtacacs scheme

Syntax
hwtacacs scheme hwtacacs-scheme-name
undo hwtacacs scheme hwtacacs-scheme-name
View
System view
1-58