H3C S7500E Series Command Manual page 482

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
[Sysname-bgp] peer test public-as-only
5.1.62 peer reflect-client
Syntax
peer { group-name | ip-address } reflect-client
undo peer { group-name | ip-address } reflect-client
View
BGP view
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
Description
Use the peer reflect-client command to configure the router as a route reflector and
specify a peer/peer group as a client.
Use the undo peer reflect-client command to remove the configuration.
By default, neither route reflector nor client is configured.
Related commands: reflect between-clients and reflect cluster-id.
Examples
# In BGP view, configure the local device as a route reflector and specify the IBGP peer
group test as a client.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test reflect-client
5.1.63 peer route-limit
Syntax
peer { group-name | ip-address } route-limit limit [ percentage ]
undo peer { group-name | ip-address } route-limit
View
BGP view
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
Chapter 5 BGP Configuration Commands
5-53