Data-Character-Bits - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

data-character-bits

Syntax
Release Information
Description
Options
Mode
472
data-character bits { 7 | 8 }
Command introduced before JunosE Release 7.1.0.
Sets the number of data bits available for characters for all sessions on the specified vty
lines. There is no no version.
7—Specifies 7 data bits per character; this setting supports only characters in the
standard ASCII set
8—Specifies 8 data bits per character; default setting, supports the full set of 8-bit
international characters
Line Configuration
Copyright © 2010, Juniper Networks, Inc.