Atm Configuration Commands; Atm-Link Check; Clock - H3C SR8800 Command Reference Manual

ATM configuration commands

atm-link check

Syntax
atm-link check
undo atm-link check
View
ATM P2P subinterface view
Default level
2: System level
Parameters
None
Description
Use the atm-link check command to make the protocol state of the current ATM P2P subinterface
adaptive to the protocol state of the PVC configured on the subinterface in addition to the state of the
physical interface. Thus, the protocol state of the subinterface is up only when both the physical interface
and the PVC configured on the subinterface are up. Otherwise, the protocol state of the subinterface is
down.
Use the undo atm-link check command to restore the default.
By default, the protocol of the ATM P2P subinterface goes up or comes down depending on the state of
the physical interface.
This command applies only to ATM P2P subinterfaces.
Examples
# Enable the protocol state of ATM P2P subinterface ATM 3/1/1.1 to change depending on the protocol
state of the physical interface and the protocol state of the PVCs configured on the subinterface.
<Sysname> system-view
[Sysname] interface Atm 3/1/1.1 p2p
[Sysname-Atm3/1/1.1] atm-link check

clock

Syntax
clock { master | slave }
undo clock
View
ATM interface view
Default level
2: System level
1