Mapd-Bd (Mapd Interface Circuit Pack Tn802) - Avaya S8700 Maintenance Manual

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

MAPD-BD (MAPD Interface Circuit Pack TN802)

MAPD-BD (MAPD Interface Circuit

(in Alarm Log)

UU is the universal cabinet number (1–64 for ATM PNC, 1–44 for CSS PNC). C is the carrier designation (A,

B, C, D, or E). SS is the number of the slot where the circuit pack resides (01–21).

The TN802 Multiple Application Platform (MAP-D) circuit pack allows sending

voice and fax from S8700 Multi-Connect through the Internet to another S8700

Multi-Connect also having this feature or to other PBXs that are equipped with the

Internet Telephony server (ITS-E).

Throughout this section the term TN802 means the MAP-D IP trunk circuit pack.

Be sure to observe these special considerations for the TN802:

Port alarms on this circuit pack display as "TIE-DS1" in the Alarm and Error

The reset board command reboots the MAPD PC CPU, but busyout

board only busies out every emulated port on the board.

Switch resets that take the switch out of service for more than 20 seconds

also cause the MAPD's PC to reboot, which takes several minutes to

Switch-Demanded Tests

Switch-demanded diagnostic tests on the TN802 do not run unless the Internet

trunking application is running on Windows NT

Initial SAT Command to

test board UUCSS sh

test board UUCSS l

test board UUCSS sh

Full Name of MO

MAPD Interface circuit pack

, located on the circuit pack.

Issue 1 May 2002