Avaya S8700 Maintenance Manual page 1749

MAINT (PN's Maintenance Circuit Pack)
Backplane Connectivity when Installed in a New System
New systems PN Control Carriers have backplane connectivity between the
TN775D Maintenance circuit pack located in slot one of the new PN Control
Carrier and the TN2312AP IPSI circuit pack located in slot two. No face plate
cable is needed.
Error Log Entries and Test to Clear Values
Table 8-405. PN's Maintenance Circuit Pack Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1 (a) 0 PN Maintenance Circuit
1 Pack Reset test (#306)
513 (a) 0 MGR I Channel Loop test
1 (#228)
769 (b) Any Sanity Handshake test
(#106)
1537 (a) 0 Sanity Maze test (#303)
1
2049 (c) Any Battery Holdover Vintage
Verification Test (#311)
2561 (a) 0 Sanity Handshake test
1 (#106)
2817 (a) 0(b) Serial Channel Loop test
1 (#229)
3329 (d) Any Serial Link Test (#337)
3585 (e) Any Serial Link Test (#337)
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
2. Major and Minor alarms may be downgraded to Warning alarms based on the value used in the set options
command.
Notes:
a. A value of 0 indicates that PNC-A (and therefore, the Expansion Interface
circuit pack located on PNC-A) was active when this error occurred. A
value of 1 indicates that PNC-B (and therefore, the Expansion Interface
circuit pack located on PNC-B) was active when this error occurred. To
clear this problem, make sure the active PNC is the same as that indicated
by the Aux Value.
555-233-143
On/Off
Alarm Level Board
Any Any
MINOR ON
MINOR ON
MINOR ON
WARNING ON
MINOR ON
MINOR ON
MINOR/ OFF
2
WARNING
MINOR/ OFF
2
WARNING
Issue 1 May 2002
Test to Clear Value
test maintenance sh r 1
test maintenance l
test maintenance sh r 3
test maintenance sh r 3
test maintenance sh r 1
test maintenance sh r 3
test maintenance sh r 3
test maintenance sh r 3
test maintenance sh r 3
8-1027