Primary Authentication; Primary Authorization - H3C s3100 series Command Manual

primary authentication

Syntax
primary authentication ip-address [ port ]
undo primary authentication
View
HWTACACS scheme view
Parameters
ip-address: IP address of the primary authentication server to be used, a valid unicast address in dotted
decimal notation.
port: Port number of the primary authentication server, ranging from 1 to 65535.
Description
Use the primary authentication command to set the IP address and port number of the primary
HWTACACS authentication server to be used by the current scheme.
Use the undo primary authentication command to restore the default IP address and port number of
the primary HWTACACS authentication server, which are 0.0.0.0 and 49 respectively.
Note that:
You are not allowed to set the same IP address for both primary and secondary authentication
servers. If you do this, your setting will fail.
If you re-execute the command, the new setting will overwrite the old one.
You can remove an authentication server setting only when there is no active TCP connection that
is sending authentication messages to the server.
Related commands: display hwtacacs.
Examples
# Set the IP address and UDP port number of the primary authentication server for HWTACACS
scheme hwt1 to 10.163.155.13 and 49 respectively.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] primary authentication 10.163.155.13 49

primary authorization

Syntax
primary authorization ip-address [ port ]
undo primary authorization
View
HWTACACS scheme view
1-72