Enable Log - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Table 3-16 Description on the fields of the display ospf vlink command
Virtual-link Neighbor-id
Neighbor-State
Interface
Cost
State
Type
Transit Area
Timers

3.1.24 enable log

Syntax
enable log [ config | error | state ]
undo enable log [ config | error | state ]
View
OSPF view
Parameters
config: Enables configuration logging.
error: Enables error logging.
state: Enables state logging.
Description
Use the enable command to enable specified OSPF logging.
Use the undo enable command to disable specified OSPF logging.
OSPF logging is disabled by default.
If no keyword is specified, all logging is enabled.
Examples
# Enable OSPF logging.
<Sysname> system-view
Field
ID of the neighbor connected to the router via the virtual
link
Neighbor State: Down, Attempt, Init, 2-Way, ExStart,
Exchange, Loading, Full.
Local interface's IP address and name of the virtual link
Interface route cost
Interface state
Type: virtual link
Transit area ID
Values of timers: hello, dead, poll (NBMA), retransmit,
and interface transmission delay
Chapter 3 OSPF Configuration Commands
Description
3-31