H3C S7500E Series Command Manual page 290

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
undo host-route
View
RIP view
Parameters
None
Description
Use the host-route command to enable host route reception.
Use the undo host-route command to disable host route reception.
By default, receiving host routes is enabled.
In some cases, a router may receive many host routes from the same network segment.
These routes are not helpful for routing and occupy a large amount of network
resources. You can use the undo host-route command to disable receiving of host
routes.
Note:
RIPv2 can be disabled from receiving host routes, but RIPv1 cannot.
Examples
# Disable RIP from receiving host routes.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] undo host-route
2.1.11 import-route
Syntax
import-route protocol [ process-id ] [ allow-jbgp ] [ cost cost | route-policy
route-policy-name | tag tag ]*
undo import-route protocol [ process-id ]
View
RIP view
Chapter 2 RIP Configuration Commands
2-12