Voice Vlan Aging; Voice Vlan Enable - H3C S7500E Series Command Manual

Command Manual – VLAN
H3C S7500E Series Ethernet Switches
Examples
# Enable the voice VLAN feature on VLAN 2 (assuming that VLAN 2 already exists).
<Sysname> system-view
[Sysname] voice vlan 2 enable

3.1.4 voice vlan aging

Syntax
voice vlan aging minutes
undo voice vlan aging
View
System view
Parameters
minutes: Aging time of a voice VLAN, in the range 5 to 43,200 (in minutes). This value is
1,440 by default.
Description
Use the voice vlan aging command to configure the aging time of a voice VLAN.
Use the undo voice vlan aging command to restore the aging time of a voice VLAN.
Under automatic mode, the system will decide whether to add a port to a voice VLAN
based on the source MAC address contained in its inbound voice packets. After adding
a port to the voice VLAN, the system will start the aging timer at the same time. If within
the aging time, no voice packets is received from the port, it will be removed from the
voice VLAN when the aging time expires.
Related commands: display voice vlan state.
Examples
# Configure the aging time of the voice VLAN as 100 minutes.
<Sysname> system-view
[Sysname] voice vlan aging 100

3.1.5 voice vlan enable

Syntax
voice vlan enable
undo voice vlan enable
Chapter 3 Voice VLAN Configuration Commands
3-4