H3C S7500E Series Command Manual page 433

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Description
Use the bestroute as-path-neglect command to configure the BGP router to not
evaluate the AS_PATH during best route selection.
Use the undo bestroute as-path-neglect command to configure the BGP router to
take the AS_PATH as a factor during best route selection.
By default, the router takes AS_PATH as a factor when selecting the best route.
Examples
# In BGP view, ignore AS_PATH in route selection.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] bestroute as-path-neglect
5.1.4 bestroute compare-med
Syntax
bestroute compare-med
undo bestroute compare-med
View
BGP view
Parameters
None
Description
Use the bestroute compare-med command to enable the comparison of the MED for
paths from each AS.
Use the undo bestroute compare-med command to disable this comparison.
This comparison is not enabled by default.
Caution:
After the bestroute compare-med command is executed, the balance command does
not take effect.
Chapter 5 BGP Configuration Commands
5-4