H3C S7500E Series Command Manual page 303

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Send RIPv1 broadcast messages
Receive RIPv1 broadcast messages
Receive RIPv1 unicast messages
When RIPv2 runs on the interface in broadcast mode, the interface will:
Send RIPv2 broadcast messages
Receive RIPv1 broadcast messages
Receive RIPv1 unicast messages
Receive RIPv2 broadcast messages
Receive RIPv2 multicast messages
Receive RIPv2 unicast messages
When RIPv2 runs on the interface in multicast mode, the interface will:
Send RIPv2 multicast messages
Receive RIPv2 broadcast messages
Receive RIPv2 multicast messages
Receive RIPv2 unicast messages
Examples
# Configure VLAN-interface 10 to broadcast RIPv2 messages.
<Sysname> system-view
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] rip version 2 broadcast
2.1.28 silent-interface
Syntax
silent-interface { all | interface-type interface-number }
undo silent-interface { all | interface-type interface-number }
View
RIP view
Parameters
all: Silents all interfaces.
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the silent-interface command to disable an interface or all interfaces from
sending routing updates. That is, the interface only receives but does not send RIP
messages.
Use the undo silent-interface command to restore the default.
Chapter 2 RIP Configuration Commands
2-25