Display Isis Spf-Log - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
IPV4 Destination
--------------------------------------------------------------------------
192.168.0.0/24
Flags: D-Direct, R-Added to RM, L-Advertised in LSPs, U-Up/Down Bit Set
IPV4 Destination
--------------------------------------------------------------------------
192.168.0.0/24
Flags: D-Direct, R-Added to RM, L-Advertised in LSPs, U-Up/Down Bit Set
Table 4-8 Description on the fields of the display isis route command
IPV4 Destination
IntCost
ExtCost
ExitInterface
NextHop
Flags

4.1.15 display isis spf-log

Syntax
display isis spf-log [ process-id ]
View
Any view
Parameters
process-id: Specifies an IS-IS process ID, in the range of 1 to 65535.
IntCost
10
ISIS(1) IPv4 Level-2 Forwarding Table
-------------------------------------
IntCost
10
Field
IPv4 destination address
Interior routing cost
Exterior routing cost
Exit interface
Next hop
Routing state flag
D: Direct route.
R: The route has been added into the routing table.
L: The route has been advertised in an LSP.
U: A route's penetration flag. Setting it to UP can prevent an
LSP sent from L2 to L1 from being sent back to L2.
Chapter 4 IS-IS Configuration Commands
ExtCost ExitInterface
NULL Vlan1
ExtCost ExitInterface
NULL Vlan1
Description
4-18
NextHop Flags
Direct D/L/-
NextHop Flags
Direct D/L/-