H3C S7500E Series Command Manual page 146

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
View
Ethernet port view
Parameters
None
Description
Use the flow-control command to enable flow control on an Ethernet port.
Use the undo flow-control command to disable flow control on an Ethernet port.
By default, flow control on an Ethernet port is disabled.
Note:
The flow control function takes effect on the local Ethernet port only when it is enabled
on both the local and peer devices.
Examples
# Enable flow control on port Ethernet 2/0/1.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] flow-control
1.1.10 flow-interval
Syntax
flow-interval interval
undo flow-interval
View
Ethernet port view
Parameters
interval: Interval for collecting port statistics, in the range 5 to 300 (in seconds). Note
that this argument must be a multiple of 5. The system default is 300 seconds.
Description
Use the flow-interval command to set the interval for collecting port statistics.
Use the undo flow-interval command to restore the default.
Chapter 1 Ethernet Port Configuration
1-13
Commands