H3C S7500E Series Command Manual page 340

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
3.1.26 filter-policy export
Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name } export [ protocol [ process-id ] ]
undo filter-policy export [ protocol [ process-id ] ]
View
OSPF view
Parameters
acl-number: Number of an ACL used to filter outgoing redistributed routes, in the range
2000 to 3999.
ip-prefix-name: Name of an IP prefix list used to filter outgoing redistributed routes, a
string of up to 19 characters.
protocol: Specifies a protocol from which to filter redistributed routes. The protocol can
be direct, static, rip, ospf, isis or bgp. If no protocol is specified, all redistributed
routes are filtered.
process-id: Process ID, which is required when the protocol is rip, ospf or isis, in the
range 1 to 65535.
Description
Use the filter-policy export command to configure the filtering of outgoing
redistributed routes.
Use the undo filter-policy export command to disable the filtering.
By default, the filtering of outgoing redistributed routes is not configured.
You can use this command to filter outgoing redistributed routes as needed.
Related commands: import-route.
Examples
# Filter outgoing redistributed routes using ACL2000.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] filter-policy 2000 export
3.1.27 filter-policy import
Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name | gateway ip-prefix-name } import
undo filter-policy import
Chapter 3 OSPF Configuration Commands
3-33