H3C S7500E Series Command Manual page 295

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
View
User view
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use the reset rip statistics command to clear the statistics of the specified RIP
process.
Examples
# Clear statistics in RIP process 100.
<Sysname> reset rip 100 statistics
2.1.17 rip
Syntax
rip [ process-id ]
undo rip [ process-id ]
View
System view
Parameters
process-id: RIP process ID, in the range of 1 to 65535. The default is 1.
Description
Use the rip command to create a RIP process and enter RIP view.
Use the undo rip command to disable a RIP process.
By default, no RIP process runs.
Note that:
You must enable the RIP process before configuring the global parameters. This
limitation is not for configuration of interface parameters.
The configured interface parameters become invalid after you disable the RIP
process.
Examples
# Create a RIP process and enter RIP process view.
<Sysname> system-view
[Sysname] rip
Chapter 2 RIP Configuration Commands
2-17