H3C S7500E Series Command Manual page 365

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – IPv4 Routing

H3C S7500E Series Ethernet Switches

virifstatechange | viriftxretransmit | virnbrstatechange ] *

undo snmp-agent trap enable ospf [ process-id ] [ ifauthfail | ifcfgerror | ifrxbadpkt

virifrxbadpkt | virifstatechange | viriftxretransmit | virnbrstatechange ] *

process-id: OSPF process ID, in the range 1 to 65535.

ifauthfail: Interface authentication failure information.

ifcfgerror: Interface configuration error information.

ifrxbadpkt: Information about error packets received.

ifstatechange: Interface state change information.

iftxretransmit: Packet receiving and forwarding information.

lsdbapproachoverflow: Information about cases approaching LSDB overflow.

lsdboverflow: LSDB overflow information.

maxagelsa: LSA max age information.

nbrstatechange: Neighbor state change information.

originatelsa: Information about LSAs originated locally.

vifauthfail: Virtual interface authentication failure information.

vifcfgerror: Virtual interface configuration error information.

virifauthfail: Virtual interface authentication failure information.

virifrxbadpkt: Information about error packets received by virtual interfaces.

virifstatechange: Virtual interface state change information.

viriftxretransmit: Virtual interface packet retransmission information.

virnbrstatechange: Virtual interface neighbor state change information.

Use the snmp-agent trap enable ospf command to enable the sending of SNMP traps

for a specified OSPF process. If no process is specified, the feature is enabled for all

Use the undo snmp-agent trap enable ospf command to disable the feature.

By default, this feature is enabled.

Refer to SNMP-RMON Commands for related information.

Chapter 3 OSPF Configuration Commands

Chapters

Table of Contents