Port-Isolate Enable - H3C S7500E Series Command Manual

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches

2.1.2 port-isolate enable

Syntax
port-isolate enable
undo port-isolate enable
View
Ethernet port view, port group view
Parameters
None
Description
Use the port-isolate enable command to add a port to the isolation group as ordinary
port only.
Use the undo port-isolate enable command to remove the port from the isolation
group.
Note that the port-isolate enable command adds a port to the system default isolation
group group1.
Configured in Ethernet port view, the setting is effective on the current port only;
configured in port group view, the setting is effective on all ports in the port group.
Examples
# Add port Ethernet 2/0/1 to the isolation group.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] port-isolate enable
# Add all the ports in port group aa to the isolation group.
[Sysname-Ethernet2/0/1] quit
[Sysname] port-group manual aa
[Sysname-port-group-manual-aa] group-member ethernet 2/0/2
[Sysname-port-group-manual-aa] group-member ethernet 2/0/3
[Sysname-port-group-manual-aa] group-member ethernet 2/0/4
[Sysname-port-group-manual-aa] port-isolate enable
Chapter 2 Port Isolation Configuration
2-2
Commands