Ospf Timer Dead - H3C S7500E Series Command Manual

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – IPv4 Routing

H3C S7500E Series Ethernet Switches

This command is not supported on the NULL interface.

# Configure the interface's network type as NBMA.

<Sysname> system-view

[Sysname] interface vlan-interface 10

[Sysname-Vlan-interface10] ospf network-type nbma

3.1.45 ospf timer dead

ospf timer dead seconds

undo ospf timer dead

Interface view

seconds: Dead interval in seconds, in the range 1 to 2147483647.

Use the ospf timer dead command to set the dead interval.

Use the undo ospf timer dead command to restore the default.

The dead interval defaults to 40s for Broadcast, P2P interfaces and defaults to 120s for

P2MP and NBMA interfaces.

If an interface receives no hello packet from the neighbor within the dead interval, the

interface considers the neighbor down. The dead interval on an interface is at least four

times the hello interval. Any two routers attached to the same segment must have the

same dead interval.

This configuration is not supported on the NULL interface.

Related commands: ospf timer hello.

# Configure the dead interval on the current interface as 60 seconds.

<Sysname> system-view

[Sysname] interface vlan-interface 10

[Sysname-Vlan-interface10] ospf timer dead 60

Chapter 3 OSPF Configuration Commands

Table of Contents