Ospf Mtu-Enable - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
Description
Use the ospf mib-binding command to bind an OSPF process to MIB operation.
Use the undo ospf mib-binding command to restore the default.
By default, MIB operation is bound to the first enabled OSPF process.
Examples
# Bind OSPF process 100 to MIB operation.
<Sysname> system-view
[Sysname] ospf mib-binding 100
# Bind the first enabled OSPF process to MIB operation.
<Sysname> system-view
[Sysname] undo ospf mib-binding

3.1.43 ospf mtu-enable

Syntax
ospf mtu-enable
undo ospf mtu-enable
View
Interface view
Parameters
None
Description
Use the ospf mtu-enable command to enable an interface to add the real MTU into DD
packets.
Use the undo ospf mtu-enable command to restore the default.
By default, an interface adds a MTU of 0 into DD packets, that is, no real MTU is added.
This configuration is not supported on the NULL interface.
Examples
# Enable the interface to add the real MTU value into DD packets.
<Sysname> system-view
[Sysname] interface vlan-interface 10
Chapter 3 OSPF Configuration Commands
3-47