H3C S7500E Series Command Manual page 347

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Parameters
maximum: Maximum number of equal cost routes for load balancing, in the range 1 to 4.
No load balancing is available when the number is set to 1.
Description
Use the maximum load-balancing command to specify the maximum number of
equal cost routes for load balancing.
Use the undo maximum load-balancing command to restore the default.
By default, the maximum number of equal cost routes is 4.
Examples
# Specify the maximum number of equal cost routes as 2.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] maximum load-balancing 2
3.1.35 maximum-routes
Syntax
maximum-routes { external | inter | intra } number
undo maximum-routes { external | inter | intra }
View
OSPF view
Parameters
external: Specifies the maximum number of external routes.
inter: Specifies the maximum number of inter-area routes.
intra: Specifies the maximum number of intra-area routes.
number: Maximum route number, in the range 0 to 131072.
Description
Use the maximum-routes command to specify the maximum route number of a
specified type, inter-area, intra-area or external.
Use the undo maximum-routes command to restore the default route maximum value
of a specified type.
By default, the maximum route number is 131072.
Chapter 3 OSPF Configuration Commands
3-40