Is-Name Map; Is-Snmp-Traps Enable - H3C S7500E Series Command Manual

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – IPv4 Routing

H3C S7500E Series Ethernet Switches

# Configure a name for the local IS.

<Sysname> system-view

[Sysname] isis

[Sysname-isis-1] is-name RUTA

4.1.41 is-name map

is-name map sys-id map-sys-name

undo is-name map sys-id

sys-id: System ID or a pseudonode ID of a remote IS.

map-sys-name: Specifies a name for the remote IS, a string of 1 to 64 characters.

Use the is-name map command to map a name to a remote IS. Each remote IS

system ID corresponds to only one name.

Use the undo is-name map command to remove the configuration.

By default, no name is configured for a remote IS.

# Map the name RUTB to the remote IS 0000.0000.0041.

<Sysname> system-view

[Sysname] isis

[Sysname-isis-1] is-name map 0000.0000.0041 RUTB

is-snmp-traps enable

undo is-snmp-traps

Chapter 4 IS-IS Configuration Commands

Table of Contents