Display Rip Route - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Table 2-3 Description on the fields of the display rip interface command
Interface-name
Address/Mask
MetricIn/Out
Version
Split-horizon
Poison-reverse
Input/Output
Current packets
number/Maximum packets
number

2.1.7 display rip route

Syntax
display rip process-id route [ statistics | ip-address { mask | mask-length } | peer
ip-address ]
View
Any view
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
statistics: Displays the route statistics, including total number of routes and number of
routes of each neighbor.
ip-address { mask | mask-length }: Displays route information about a specified IP
address.
peer ip-address: Displays all routing information learned from a specified neighbor.
Description
Use the display rip route command to display the routing information of a specified
RIP process.
Current packets number/Maximum packets number: 234/2000
Field
Chapter 2 RIP Configuration Commands
Description
The name of an interface running RIP.
The IP address and Mask of the interface.
Additional routing metric added to the incoming
and outgoing routes
RIP version running on the interface
Indicates whether the split-horizon is enabled (ON:
enabled, OFF: disabled).
Indicates whether the poison-reverse is enabled
(ON: enabled, OFF: disabled)
Indicates if the interface is allowed to receive
(Input) or send (Output) RIP messages (on is
allowed, off is not allowed).
Packets to be sent/Maximum packets that can be
sent on the interface
2-7