Display Ospf Peer Statistics - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches

3.1.19 display ospf peer statistics

Syntax
display ospf [ process-id ] peer statistics
View
Any view
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
Description
Use the display ospf peer statistics command to display OSPF neighbor statistics.
If no OSPF process is specified, OSPF neighbor statistics of all OSPF processes is
displayed.
Examples
# Display OSPF neighbor statistics.
<Sysname> display ospf peer statistics
Area ID
0.0.0.1
Total
Table 3-12 Description on the fields of the display ospf peer statistics command
Field
Area ID
Down
Attempt
Init
2-Way
OSPF Process 1 with Router ID 1.1.1.1
Neighbor Statistics
Down Attempt Init 2-Way ExStart Exchange Loading Full Total
0 0 0
0 0 0
Area ID
Under this state, neighbor initial state, the router has not received
any information from a neighboring router for a period of time.
Available only in an NBMA network, such as Frame Relay, X.25 or
ATM. Under this state, the OSPF router has not received any
information from a neighbor for a period but can send Hello packets
with a longer interval to keep neighbor relationship.
Under this state, the router has received a hello packet from a
neighbor but the packet contains no IP address of itself, so mutual
communication is not established.
Indicates mutual communication between the router and its
neighbor is established. DR/BDR election is finished under this state
(or higher).
3-25
Chapter 3 OSPF Configuration Commands
0 0 0
0 0 0
Description
0 1 1
0 1 1