H3C S7500E Series Command Manual page 140

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Table 1-3 Description on the fields of the display interface command (in bridge mode)
Ethernet2/0/1 current state
IP Packet Frame Type
Hardware address
Description
Loopback is not set
Unknown-speed mode
unknown-duplex mode
Link speed type is
autonegotiation
link duplex type is
autonegotiation
Flow-control is not enabled
The Maximum Frame Length
Broadcast MAX-ratio
Unicast MAX-ratio
Multicast MAX-ratio
PVID
Mdi type
Link delay
Port link-type
Tagged VLAN ID
Untagged VLAN ID
Field
Current physical link state of the Ethernet port
Frame type of the Ethernet port
Hardware address
Description of the port
Loopback is not configured
Unknown-speed mode, in which mode speed is
negotiated between the current host and the peer
unknown-duplex mode, in which mode speed is
negotiated between the current host and the peer
Link speed type is autonegotiation
Link duplex type is autonegotiation
Flow-control is not enabled
The maximum frame length allowed on a port
Broadcast storm suppression ratio (the maximum
ratio of allowed number of broadcast packets to
overall traffic through a port)
Unicast storm suppression ratio (the maximum ratio
of allowed number of unknown unicast packets to
overall traffic through a port)
Multicast storm suppression ratio (the maximum
ratio of allowed number of multicast packets to
overall traffic through a port)
Default VLAN ID
Cable type
Suppression time of physical-link-state changes on
an Ethernet Port.
Port link type, which could be access, trunk, and
hybrid.
Identify the VLANs that need Tag markers
Identify the VLANs that do not need Tag markers
Chapter 1 Ethernet Port Configuration
Description
1-7
Commands