Isis Silent - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Note:
A mesh-group is only available for a point-to-point link interface.
This command is not available in loopback interface view.
Examples
# Add IS-IS enabled VLAN-interface 10 to the mesh-group 3.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis mesh-group 3

4.1.32 isis silent

Syntax
isis silent
undo isis silent
View
Interface view
Parameters
None
Description
Use the isis silent command to disable the interface from sending and receiving IS-IS
hello packets.
Use the undo isis silent command to restore the default.
By default, an interface is not disabled from sending and receiving hello packets.
Note:
The feature is not supported on the loopback interface.
Examples
# Disable VLAN-interface 10 from sending and receiving hello packets.
<Sysname> system-view
[Sysname] interface vlan-interface10
Chapter 4 IS-IS Configuration Commands
4-36