H3C S7500E Series Command Manual page 147

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Examples
# Set the interval for collecting statistics to 100 seconds on Ethernet 2/0/1.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] flow-interval 100
1.1.11 group-member
Syntax
group-member interface-list
undo group-member interface-list
View
Port group view
Parameters
interface-list: Ethernet port list, in the form of interface-type interface-number [ to
interface-type interface-number ] &<1-10>, where &<1-10> indicates that you can
specify up to 10 port or port ranges
Description
Use the group-member command to add an Ethernet port to a specified manual port
group.
Use the undo group-member command to remove a specified Ethernet port from a
manual port group.
By default, a manual port group is empty, that is, there is no Ethernet port in it.
Examples
# Add port Ethernet 2/0/1 to the manual port group named group 1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member ethernet 2/0/1
1.1.12 interface
Syntax
interface interface-type interface-number
View
System view
Chapter 1 Ethernet Port Configuration
1-14
Commands