H3C S7500E Series Command Manual page 149

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Note:
If you execute the jumboframe enable command repeatedly, the latest configuration
takes effect.
Examples
# Enable jumbo frames under 1560 bytes to pass through Ethernet port 2/0/1.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] jumboframe enable 1560
# Enable jumbo frames to pass through all the Ethernet ports in the manual port group
named group1.
[Sysname-Ethernet2/0/1] quit
[Sysname] port-group manual group1
[Sysname-port-group manual group1] group-member ethernet 2/0/2
[Sysname-port-group manual group1] group-member ethernet 2/0/3
[Sysname-port-group manual group1] jumboframe enable
1.1.14 link-delay
Syntax
link-delay delay-time
undo link-delay
View
Ethernet port view
Parameters
delay-time: Up/down suppression time for the physical connection of an Ethernet port
(in seconds). The value ranges from 0 to 30. The system default is 0.
Description
Use the link-delay command to configure the suppression time of physical-link-state
changes on an Ethernet Port.
Use the undo link-delay command to restore the default suppression time.
The default suppression time of physical-link-state changes on an Ethernet port is 0
seconds, indicating that if the port state changes, the port reports the change to the
system immediately.
Chapter 1 Ethernet Port Configuration
1-16
Commands