Display Isis Mesh-Group - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Description
Use the display isis lsdb command to display IS-IS link state database.
Examples
# Display Level-1 LSDB information.
<Sysname> dis isis lsdb level-1
LSPID
--------------------------------------------------------------------------
bbbb.cccc.dddd.00-00* 0x0000001d 0x165
*-Self LSP, +-Self LSP(Extended), ATT-Attached, P-Partition, OL-Overload
Table 4-4 Description on the fields of the display isis lsdb command
LSPID
Seq Num
Checksum
Holdtime
Length
ATT/P/OL

4.1.11 display isis mesh-group

Syntax
display isis mesh-group [ process-id ]
View
Any view
Parameters
process-id: Specifies an IS-IS process ID, in the range of 1 to 65535.
Database information for ISIS(1)
--------------------------------
Level-1 Link State Database
Seq Num Checksum
Field
4-13
Chapter 4 IS-IS Configuration Commands
Holdtime
820
Description
Link state packet ID
LSP sequence number
LSP checksum
LSP holdtime
LSP length
Attach bit (ATT)
Partition bit (P)
Overload bit (OL)
Length ATT/P/OL
36 1/0/0