H3C S7500E Series Command Manual page 72

Command Manual – VLAN
H3C S7500E Series Ethernet Switches
2.1.2 isolate-user-vlan
Syntax
isolate-user-vlan isolate-user-vlan-id secondary secondary-vlan-id-list
undo isolate-user-vlan isolate-user-vlan-id [ secondary secondary-vlan-id-list ]
View
System view
Parameters
isolate-user-vlan-id: VLAN ID of an isolate-user-vlan, in the range 1 to 4094.
secondary secondary-vlan-id-list: Specifies a list of secondary VLAN IDs. You need to
provide the secondary-vlan-id argument in the form of { secondary-vlan-id1 [ to
secondary-vlan-id2 ] }&<1-10>, where secondary-vlan-id1 and secondary-vlan-id2 are
VLAN IDs in the range 1 to 4094 and &<1-10> means that you can provide up to ten
secondary VLAN IDs/secondary VLAN ID ranges.
Description
Use the isolate-user-vlan command to create the mapping between an
isolate-user-vlan and the secondary VLAN(s).
Use the undo isolate-user-vlan command to delete the mapping between an
isolate-user-vlan and the secondary VLANs.
By default, there is no mapping between the isolate-user-vlan and the secondary
VLANs.
Note that:
To use the isolate-user-vlan command, the isolate-user-vlan and the secondary
VLAN must have at least a port, which allows the isolate-user-vlan or the
secondary VLAN to pass. The default VLAN of the port must be the
isolate-user-vlan or the secondary VLAN. Otherwise, the command can not be
used.
Use of the undo isolate-user-vlan command without the secondary
secondary-vlan-id parameter will delete the mapping between the specified
isolate-user-vlan and all secondary VLANs, while use of the command with the
parameter will only delete the mapping between the specified isolate-user-vlan
and the specified secondary VLANs.
Chapter 2 Isolate-User-VLAN Configuration Commands
2-3