Display Protocol-Vlan Vlan - H3C S7500E Series Command Manual

Command Manual – VLAN
H3C S7500E Series Ethernet Switches

1.3.2 display protocol-vlan vlan

Syntax
display protocol-vlan vlan { vlan-id [ to vlan-id ] | all }
View
Any view
Parameters
vlan-id: VLAN ID, in the range 1 to 4094.
to: Specifies VLAN range, the value after this parameter must be greater than or equal
to that before it.
all: All VLANs.
Description
Use the display protocol-vlan vlan command to display the protocol information and
protocol index configured on the specified VLAN(s).
Related commands: display vlan.
Examples
# Display the protocol information and protocol index configured on all
protocol-based-VLANs.
<Sysname> display protocol-vlan vlan all
VLAN ID:2
Protocol Index
======================================================
VLAN ID:3
Protocol Index
======================================================
Refer to
Protocol Type
0 ipv4
3 ipx ethernetii
Protocol Type
0 ipv4
1 ipx snap
Table 1-1 for description on the output fields.
Chapter 1 VLAN Configuration Commands
1-16