H3C S7500E Series Command Manual page 278

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Description
Use the ip route-static default-preference command to configure the default
preference for static routes.
Use the undo ip route-static default-preference command to restore the default.
By default, the default preference of static routes is 60.
Note that:
If no preference is specified when configuring a static route, the default preference
is used.
When the default preference is re-configured, it applies to newly added static
routes only.
Related commands: display ip routing-table, ip route-static.
Examples
# Set the default preference of static routes to 120.
<Sysname> system-view
[Sysname] ip route-static default-preference 120
Chapter 1 Static Routing Configuration Commands
1-4