Ip Check Source - H3C S7500E Series Command Manual

Command Manual – IP Source Guard
H3C S7500E Series Ethernet Switches
<Sysname> display user-bind
The following user address bindings have been configured:
MAC
N/A
0002-0002-0002
------------------2 binding entries queried, 2 listed------------------
Table 1-2 Description on the fields of the display user-bind command
MAC
IP
Vlan
Port
Status
2 binding entries queried,
2 listed

1.1.3 ip check source

Syntax
ip check source { ip-address | ip-address mac-address | mac-address }
undo ip check source
View
Ethernet port view
Parameters
ip-address: Specifies to bind source IP addresses to the port.
mac-address: Specifies to bind source MAC addresses to the port.
Description
Use the ip check source command to configure the dynamic binding function on a
port.
Use the undo ip check source command to restore the default.
By default, the dynamic binding function is disabled.
IP
1.1.1.1
1.1.1.1
Field
MAC address of the binding. N/A means that no MAC
address is bound in the entry.
IP address of the binding. N/A means that no IP
address is bound in the entry.
Static binding entry does not support VLAN-port
binding.
Port of the binding
Type of the binding. Static means that the binding is
manually configured.
Counts of static binding entries
Chapter 1 IP Source Guard Commands
Vlan Port
N/A Ethernet2/0/6
N/A Ethernet2/0/6
Description
1-3
Status
Static
Static