Ospf Dr-Priority; Ospf Mib-Binding - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Examples
# Set the OSPF cost for the interface to 65.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf cost 65

3.1.41 ospf dr-priority

Syntax
ospf dr-priority priority
undo ospf dr-priority
View
Interface view
Parameters
priority: DR Priority of the interface, in the range 0 to 255.
Description
Use the ospf dr-priority command to set the priority for DR/BDR election on an
interface.
Use the undo ospf dr-priority command to restore the default value.
By default, the priority is 1.
The bigger the value, the higher the priority.
This configuration is not supported on the NULL interface and loopback interfaces.
Examples
# Set the DR priority on the current interface to 8.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf dr-priority 8

3.1.42 ospf mib-binding

Syntax
ospf mib-binding process-id
undo ospf mib-binding
View
System view
Chapter 3 OSPF Configuration Commands
3-46