H3C S7500E Series Command Manual page 313

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
limit: Specifies the default upper limit of routes redistributed per time, in the range 1 to
2147483647.
tag: Specifies the default tag for redistributed routes, in the range 0 to 4294967295.
type: Specifies the default type for redistributed routes: 1 or 2.
Description
Use the default command to configure default parameters for redistributed routes.
Use the undo default command to restore default values.
The cost, route type, tag, and the upper limit are 1, 2, 1 and 1000 by default.
Related commands: import-route.
Examples
# Configure the default cost, upper limit, tag and type as 10, 20000, 100 and 2
respectively for redistributed external routes.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] default cost 10 limit 20000 tag 100 type 2
3.1.7 default-cost
Syntax
default-cost cost
undo default-cost
View
OSPF area view
Parameters
cost: Specifies a cost for the default route advertised to the Stub or NSSA area, in the
range 0 to 16777214.
Description
Use the default-cost command to specify a cost for the default route advertised to the
stub or NSSA area.
Use the undo default-cost command to restore the default value.
The cost defaults to 1.
This command is only applicable to the ABR of a stub area or the ABR/ASBR of an
NSSA area.
Related commands: stub, nssa.
Chapter 3 OSPF Configuration Commands
3-6