Reset Isis Peer - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Parameters
process-id: Clears the data structure information of an IS-IS process numbered from 1
to 65535.
Description
Use the reset isis all command to clear all ISIS data structure information.
No data structure information is cleared by default.
This command is used when the LSP needs to be updated immediately. For example,
after performing the area-authentication-mode and domain-authentication-mode
commands, you can use this command to clear old LSPs.
Related commands: area-authentication-mode, domain authentication-mode.
Examples
# Clear all IS-IS data structure information.
<Sysname> reset isis all

4.1.51 reset isis peer

Syntax
reset isis peer system-id [ process-id ]
View
User view
Parameters
system-id: Specifies the system ID of an IS-IS neighbor.
process-id: Specifies the ID of an IS-IS process, in the range of 1 to 65535.
Description
Use the reset isis peer command to clear the data structure information of a specified
IS-IS neighbor.
The command is disabled by default.
This command is used when you need to re-establish an IS-IS neighbor.
Examples
# Clear the data structure information of the neighbor with system ID being
0000.0c11.1111.
<Sysname> reset isis peer 0000.0c11.1111
Chapter 4 IS-IS Configuration Commands
4-51