Display Ospf Request-Queue - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Field
ExStart
Exchange
Loading
Full
Total

3.1.20 display ospf request-queue

Syntax
display ospf [ process-id ] request-queue [ interface-type interface-number ]
[ neighbor-id ]
View
Any view
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
interface-type interface-number: Interface type and number.
neighbor-id: Neighbor's router ID.
Description
Use the display ospf request-queue command to display OSPF request queue
information.
If no OSPF process is specified, the OSPF request queue information of all OSPF
processes is displayed.
Examples
# Display OSPF request queue information.
<Sysname> display ospf request-queue
The Router's Neighbor is Router ID 2.2.2.2
Interface 10.1.1.1
Under this state, the router decides on sequence numbers for DD
packets.
Under this state, the router exchanges link state information with the
neighbor.
Under this state, the router requests the neighbor for needed LSAs.
Indicates LSDB synchronization has been accomplished between
neighbors.
Total number of neighbors under the same state
OSPF Process 1 with Router ID 1.1.1.1
OSPF Request List
Chapter 3 OSPF Configuration Commands
Description
Area 0.0.0.0
3-26
Address 10.1.1.2