H3C S7500E Series Command Manual page 330

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
View
Any view
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
verbose: Displays detailed neighbor information.
interface-type interface-number: Interface type and interface number.
neighbor-id: Neighbor router ID.
Description
Use the display ospf peer command to display information about OSPF neighbors.
Note that:
If no OSPF process is specified, OSPF neighbor information of all OSPF processes is
displayed.
If an interface is specified, the neighbor on the interface is displayed.
If a neighbor ID is specified, detailed information about the neighbor is displayed,
If neither interface nor neighbor ID is specified, brief information about neighbors of the
specified OSPF process or all OSPF processes is displayed.
Examples
# Display detailed OSPF neighbor information.
<Sysname> display ospf peer verbose
Area 0.0.0.1 interface 192.168.0.138(Vlan-interface1)'s neighbors
Router ID: 192.168.0.136
State: Full
DR: 192.168.0.138
Dead timer due in 40
Neighbor is up for 00:12:59
Authentication Sequence: [ 0 ]
Neighbor state change count: 5
Table 3-10 Description on the fields of the display ospf peer verbose command
Router ID
Address
OSPF Process 1 with Router ID 192.168.0.138
Neighbors
Mode: Nbr is Slave
BDR: 192.168.0.136
sec
Field
Neighbor router ID
Neighbor router address
Chapter 3 OSPF Configuration Commands
Address: 192.168.0.136
Priority: 1
MTU: 0
Description
3-23
GR State: Normal