H3C S7500E Series Command Manual page 91

Command Manual – VLAN
H3C S7500E Series Ethernet Switches
4.2.6 gvrp
Syntax
gvrp
undo gvrp
View
System view, Ethernet port view, port group view
Parameters
None
Description
Use the gvrp command to enable GVRP globally, on a port, or on all ports in a port
group depending on the view you entered.
Use the undo gvrp command to disable GVRP globally, on a port, or on all ports in a
port group depending on the view you entered.
By default, GVRP is disabled.
Execution of the above commands in system view, will apply the configurations globally,
in Ethernet port view will apply the configurations to the current port, and in port group
view will apply the configurations to all the ports in the port group.
Note:
To enable GVRP on a port, you need to enable it globally.
The port where you enable/disable GVRP must be a trunk port.
BPDU Tunnel is incompatible with GVRP. Before enabling GVRP, disable BPDU
Tunnel.
Isolate-user-vlan is incompatible with global GVRP. Make sure that no
Isolate-user-vlan has been created on the device before enabling GVRP.
Related commands: display gvrp status.
Examples
# Enable GVRP globally.
Chapter 4 GARP/GVRP Configuration Commands
Operations of creating VLAN
Operations of deleting VLAN
Operations of adding VLAN to TRUNK
Operations of deleting VLAN from TRUNK
4-9
: 2-100
: none
: 2-100
: none