Display Link-Aggregation Verbose - H3C S7500E Series Command Manual

Command Manual – Link Aggregation
H3C S7500E Series Ethernet Switches

1.1.5 display link-aggregation verbose

Syntax
display link-aggregation verbose [ agg-id ]
View
Any view
Parameters
agg-id: ID of an existing link aggregation group.
Description
Use the display link-aggregation verbose command to display detailed information
about the specified or all link aggregation groups.
You may find that information about the remote system for a manual link aggregation
group is either replaced by none or not displayed at all. This is normal because this type
of aggregation group has no knowledge of its partner.
Examples
# Display detailed information about all the link aggregation groups.
<Sysname> display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Flags:
Aggregation ID: 1,
Aggregation Description:
System ID: 0x8000, 0000-fc00-6504
Port Status: S -- Selected,
Local:
Port
-------------------------------------------------------------------------
Eth2/0/23
Remote:
Actor
-------------------------------------------------------------------------
Eth2/0/23
A -- LACP_Activity, B -- LACP_timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
AggregationType: Manual,
Status
S
Partner Priority
0
Chapter 1 Link Aggregation Configuration Commands
U -- Unselected
Priority Oper-Key
32768 1
Oper-Key
0 0
1-6
Loadsharing Type: Shar
Flag
{}
SystemID
0x0000,0000-0000-0000
Flag
{}