H3C S7500E Series Command Manual page 447

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Received: Total 5 messages, Update messages 1
Sent: Total 4 messages, Update messages 0
Maximum allowed prefix number: 4294967295
Threshold: 75%
Minimum time between advertisement runs is 30 seconds
Optional capabilities:
Route refresh capability has been enabled
Peer Preferred Value: 0
Routing policy configured:
No routing policy is configured
Table 5-5 Description on the fields of the display bgp peer command
Peer
Local
Type
BGP version
remote router ID
BGP current state
BGP current event
BGP last state
Port
Configured: Active Hold Time
Keepalive Time
Received: Active Hold Time
Negotiated: Active Hold Time
Peer optional capabilities
Received : Active Hold Time: 180 sec
Negotiated: Active Hold Time: 180 sec
Peer optional capabilities:
Peer support bgp multi-protocol extended
Peer support bgp route refresh capability
Address family IPv4 Unicast: advertised and received
Field
Chapter 5 BGP Configuration Commands
Description
IP address of the peer
Local router ID
Peer type: Internal as IBGP peers and External
as EBGP peers.
BGP protocol version
Router ID of the peer
Current state of the peer
Current event of the peer
Last state of the peer
Port number of local router and its peer
Local holdtime interval
Local keepalive interval
Remote holdtime interval
Negotiated holdtime interval
Optional capabilities supported by the peer,
including BGP multiple extension and routing
refresh.
5-18