H3C S7500E Series Command Manual page 319

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
Description
Use the display ospf brief command to display OSPF brief information. If no OSPF
process is specified, brief information about all OSPF processes is displayed.
Examples
# Display OSPF brief information.
<Sysname> display ospf brief
RouterID: 192.168.1.2
Route Tag: 0
Multi-VPN-Instance is not enabled
Applications Supported: MPLS Traffic-Engineering
SPF-schedule-interval: 5 0 5000
LSA generation interval: 5 0 5000
LSA arrival interval: 1000
Default ASE Parameter: Metric: 1 Tag: 1 Type: 2
Route Preference: 10
ASE Route Preference: 150
SPF Computation Count: 22
RFC 1583 Compatible
Graceful restart interval: 120
Area Count: 1
ExChange/Loading Neighbors: 0
Area: 0.0.0.1
Authtype: None Area flag: NSSA
SPF Scheduled Count: 5
ExChange/Loading Neighbors: 0
Interface: 192.168.1.2 (Vlan-interface1)
Cost: 1
Priority: 1
Designated Router: 192.168.1.2
Backup Designated Router: 192.168.1.1
Timers: Hello 10 , Dead 40 , Poll
OSPF Process 1 with Router ID 192.168.1.2
OSPF Protocol Information
Border Router:
Nssa Area Count: 1
(MPLS TE
State: DR
Chapter 3 OSPF Configuration Commands
NSSA
not enabled)
Type: Broadcast
40 , Retransmit 5 , Transmit Delay 1
3-12
MTU: 1500