H3C S7500E Series Command Manual page 247

Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches
Field
State
Age
Tag
Route status:
Active This is an active unicast route.
Adv This route can be advertised.
Delete This route is deleted.
Gateway This is an indirect route.
Number of holddown routes. Holddown is a route
advertisement policy used in some distance vector
(D-V) routing protocols, such as RIP, to avoid the
propagation of some incorrect routes. It distributes
Holddown
a Holddown route during a period regardless of
whether a new route to the same destination is
found. For details, refer to corresponding routing
protocols.
The route was discovered by an Internal Gateway
Int
Protocol (IGP).
The route is not advertised when the router
NoAdv
advertises routes based on policies.
Normally, among routes to a destination, the route
with the highest preference is installed into the
NotInstall core routing table and advertised, while a
NotInstall route cannot be installed into the core
routing table but may be advertised.
The packets matching a Reject route will be
dropped. Besides, the router sends ICMP
Reject unreachable messages to the sources of the
dropped packets. The Reject routes are usually
used for network testing.
A static route is not lost when you perform the save
Static operation and then restart the router. Routes
configured manually are marked as static.
Unicast Unicast routes
Inactive Inactive routes
Invalid Invalid routes
WaitQ The route is the WaitQ during route recursion.
TunE Tunnel
GotQ The route is in the GotQ during route recursion.
Time for which the route has been in the routing table, in the
sequence of hour, minute, and second from left to right.
Route tag
1-7
Chapter 1 Routing Overview Commands
Description