H3C S7500E Series Command Manual page 139

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
If both port type and port number are specified, then only information of the
specified port will be displayed.
Related commands: interface.
Examples
# Display the current state of port Ethernet 2/0/1 and related information.
<Sysname> display interface ethernet 2/0/1
Ethernet2/0/1 current state: DOWN
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e200-2200
Description: Ethernet2/0/1 Interface
Loopback is not set
Media type is twisted pair, Port hardware type is 100_BASE_TX
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 1536
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
PVID: 1
Mdi type: auto
Link delay is 0(sec)
Port link-type: access
Tagged
Untagged VLAN ID : 1
Port priority: 0
Last 300 seconds input:
Last 300 seconds output:
Input (total):
Input (normal):
Input:
Output (total): 0 packets, 0 bytes
Output (normal): 0 packets, - bytes
Output: 0 output errors, - underruns, - buffer failures
VLAN ID : none
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
0 packets, 0 bytes
0 broadcasts, 0 multicasts
0 packets, - bytes
0 broadcasts, 0 multicasts
0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
0 broadcasts, 0 multicasts, 0 pauses
0 broadcasts, 0 multicasts, 0 pauses
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
Chapter 1 Ethernet Port Configuration
1-6
Commands
-%
-%